Roseville Roof Pros provides professional chimney flashing in Roseville, CA for residential and commercial properties across south Placer County. Ask for chimney flashing in most cities and you get a conversation about step flashing and mortar reglets on a masonry stack. In Roseville that is the minority case. What the builders here overwhelmingly installed was a factory-built metal flue inside a framed chase clad in stucco or siding.
That changes the diagnosis completely. A framed chase does not leak at the step flashing very often at all. It leaks at the top, through the chase-cover pan, which is the flat sheet-metal lid the entire assembly depends on and the one part of your house that nobody, including the last three roofers who quoted you, has ever actually looked at.
The original pans were commonly light galvanised steel, formed nearly flat with no cross-slope and with a seam at each corner that was either soldered thinly or simply caulked. Twenty years of standing water and valley sun later, the seams have opened, the pan has rusted through at the low spot, and water is running down the outside of the flue into the framing.
Right behind it is the storm collar, the small conical band that seals the flue pipe where it passes up through the pan. It is held by a single bead of sealant with a service life of well under a decade, and it can be replaced on the same visit, cheaply, if anyone ever thinks to look at it. Almost nobody does, and it causes an unreasonable share of the chimney leaks in this city.
Our repair is a new pan fabricated to the chase with a proper cross-slope, a turned-down drip edge past the cladding, cross-broken to shed water, and welded or mechanically seamed rather than caulked, plus a new storm collar. Where the chase meets a roof plane we then do the ordinary work properly: step flashing lapped into each course, a cricket on the uphill side of any chase wider than thirty inches, and counterflashing cut into the substrate.
If you do have a genuine masonry stack, which turns up on the older east-side streets and out in Auburn and Marysville, we treat it as masonry: reglet-cut counterflashing, repointing where the joints require it, a proper crown and a cap. That is real work and we do it. It is simply not what most of Roseville has behind its stucco.
Our licensed and insured team brings the right materials and equipment to every job — EPDM pipe-jack boot collars, lead-sleeve plumbing jacks, the self-seal adhesive strip on laminated shingles, surface-mount counterflashing bedded in mastic, seven-sixteenths OSB roof sheathing with H-clips, sand-cast concrete tile with mortar-set hip and ridge — and backs the work with a written workmanship warranty. We serve Roseville and nearby communities including Rocklin, Lincoln, Granite Bay, Loomis.
What We Handle
Everything our chimney flashing in Roseville covers
One crew, one point of contact, and the full range of chimney flashing work in Roseville, CA. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair roseville
- chimney leak roseville ca
- chase cover replacement placer county
- chimney chase leak roseville
- storm collar replacement roseville ca
- step flashing repair roseville
- chimney cricket roseville california
- counterflashing repair roseville
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Roseville services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with EPDM pipe-jack boot collars, lead-sleeve plumbing jacks, the self-seal adhesive strip on laminated shingles, surface-mount counterflashing bedded in mastic, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Roseville job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in south Placer County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Roseville
Roseville Roof Pros covers Roseville and the surrounding communities of south Placer County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Rocklin, CA — Placer County, population 71,601
- Chimney Flashing in Lincoln, CA — Placer County, population 49,757
- Chimney Flashing in Granite Bay, CA — Placer County, population 21,247
- Chimney Flashing in Loomis, CA — Placer County, population 6,836
- Chimney Flashing in Auburn, CA — Placer County, population 13,776
- Chimney Flashing in North Auburn, CA — Placer County, population 13,452
Start on the Roseville Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Roseville Chooses Roseville Roof Pros
- ✓We pull the permit history and date the build phase before quoting, because a 1996 roof and a 2006 roof in the same city are different products with different details.
- ✓Inspections return a remaining-life range per component, not one verdict for the whole roof, so the shingle field and the rubber parts are priced on their own clocks.
- ✓We recommend detail renewal over replacement whenever the field is sound, and we put the recommendation to do nothing in writing with a date to look again.
- ✓On a framed chimney chase we replace the chase-cover pan with a cross-sloped, seamed unit rather than caulking the original flat one back together.
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Roseville follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Roseville gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Roseville, or request a quote and we'll get right back to you.